diff --git a/target/linux/realtek/dts/rtl9303_xikestor_sks7300-4x4t.dts b/target/linux/realtek/dts/rtl9303_xikestor_sks7300-4x4t.dts new file mode 100644 index 0000000000..31ade4bc40 --- /dev/null +++ b/target/linux/realtek/dts/rtl9303_xikestor_sks7300-4x4t.dts @@ -0,0 +1,292 @@ +// SPDX-License-Identifier: GPL-2.0-or-later + +#include "rtl930x.dtsi" + +#include +#include +#include + +/ { + compatible = "xikestor,sks7300-4x4t", "realtek,rtl9303-soc"; + model = "XikeStor SKS7300-4X4T"; + + aliases { + label-mac-device = ðernet0; + led-boot = &led_sys; + led-failsafe = &led_sys; + led-running = &led_sys; + led-upgrade = &led_sys; + }; + + memory@0 { + device_type = "memory"; + reg = <0x00000000 0x10000000>, /* first 256 MiB */ + <0x20000000 0x10000000>; /* remaining 256 MiB */ + }; + + chosen { + stdout-path = "serial0:115200n8"; + /* Silencing the kernel is required since otherwise the watchdog + would time out! */ + bootargs = "quiet"; + }; + + watchdog { + compatible = "linux,wdt-gpio"; + gpios = <&gpio0 20 GPIO_ACTIVE_HIGH>; + hw_algo = "toggle"; + hw_margin_ms = <1200>; + always-running; + }; + + keys { + compatible = "gpio-keys"; + + button-reset { + label = "reset"; + gpios = <&gpio0 17 GPIO_ACTIVE_LOW>; + linux,code = ; + }; + }; + + leds { + compatible = "gpio-leds"; + + pinctrl-names = "default"; + pinctrl-0 = <&pinmux_enable_led_sync>, <&pinmux_disable_sys_led>; + + led_sys: led-0 { + color = ; + function = LED_FUNCTION_STATUS; + gpios = <&gpio0 0 GPIO_ACTIVE_HIGH>; + linux,default-trigger = "heartbeat"; + }; + }; + + led_set { + compatible = "realtek,rtl9300-leds"; + active-low; + + /* [Amber] [Green] */ + led_set0 = <(RTL93XX_LED_SET_5G | RTL93XX_LED_SET_2P5G | RTL93XX_LED_SET_1G | + RTL93XX_LED_SET_100M | RTL93XX_LED_SET_10M | RTL93XX_LED_SET_LINK | + RTL93XX_LED_SET_ACT) + (RTL93XX_LED_SET_10G | RTL93XX_LED_SET_LINK | RTL93XX_LED_SET_ACT)>; + }; + + i2c_gpio { + compatible = "i2c-gpio"; + #address-cells = <1>; + #size-cells = <0>; + i2c-gpio,delay-us = <2>; + scl-gpios = <&gpio0 9 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>; + sda-gpios = <&gpio0 10 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>; + + temperature_sensor: temperature-sensor@48 { + compatible = "national,lm75"; + reg = <0x48>; + #thermal-sensor-cells = <0>; + }; + }; + + sfp0: sfp-p1 { + compatible = "sff,sfp"; + i2c-bus = <&i2c2>; + los-gpio = <&gpio1 2 GPIO_ACTIVE_HIGH>; + mod-def0-gpio = <&gpio1 1 GPIO_ACTIVE_LOW>; + tx-disable-gpio = <&gpio1 0 GPIO_ACTIVE_HIGH>; + maximum-power-milliwatt = <1500>; + #thermal-sensor-cells = <0>; + }; + + sfp1: sfp-p2 { + compatible = "sff,sfp"; + i2c-bus = <&i2c3>; + los-gpio = <&gpio1 5 GPIO_ACTIVE_HIGH>; + mod-def0-gpio = <&gpio1 4 GPIO_ACTIVE_LOW>; + tx-disable-gpio = <&gpio1 3 GPIO_ACTIVE_HIGH>; + maximum-power-milliwatt = <1500>; + #thermal-sensor-cells = <0>; + }; + + sfp2: sfp-p3 { + compatible = "sff,sfp"; + i2c-bus = <&i2c4>; + los-gpio = <&gpio1 8 GPIO_ACTIVE_HIGH>; + mod-def0-gpio = <&gpio1 7 GPIO_ACTIVE_LOW>; + tx-disable-gpio = <&gpio1 6 GPIO_ACTIVE_HIGH>; + maximum-power-milliwatt = <1500>; + #thermal-sensor-cells = <0>; + }; + + sfp3: sfp-p4 { + compatible = "sff,sfp"; + i2c-bus = <&i2c6>; + los-gpio = <&gpio1 11 GPIO_ACTIVE_HIGH>; + mod-def0-gpio = <&gpio1 10 GPIO_ACTIVE_LOW>; + tx-disable-gpio = <&gpio1 9 GPIO_ACTIVE_HIGH>; + maximum-power-milliwatt = <1500>; + #thermal-sensor-cells = <0>; + }; +}; + +&i2c_mst1 { + status = "okay"; + + i2c2: i2c@2 { + reg = <2>; + }; + i2c3: i2c@3 { + reg = <3>; + }; + i2c4: i2c@4 { + reg = <4>; + }; + i2c6: i2c@6 { + reg = <6>; + }; +}; + +&mdio_aux { + status = "okay"; + + gpio1: gpio@0 { + compatible = "realtek,rtl8231"; + reg = <0>; + + gpio-controller; + #gpio-cells = <2>; + gpio-ranges = <&gpio1 0 0 37>; + + led-controller { + compatible = "realtek,rtl8231-leds"; + status = "disabled"; + }; + }; +}; + +&spi0 { + status = "okay"; + + flash@0 { + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <10000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x0 0xa0000>; + read-only; + }; + + partition@a0000 { + label = "u-boot-env"; + reg = <0xa0000 0x10000>; + + nvmem-layout { + compatible = "u-boot,env"; + + macaddr_ubootenv_ethaddr: ethaddr { + #nvmem-cell-cells = <1>; + }; + }; + }; + + partition@b0000 { + label = "reserve"; + reg = <0xb0000 0x80000>; + read-only; + }; + + partition@130000 { + label = "config"; + reg = <0x130000 0x350000>; + read-only; + }; + + partition@480000 { + label = "firmware"; + reg = <0x480000 0x1b80000>; + + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "kernel"; + reg = <0x0 0x800000>; + }; + + partition@800000 { + label = "rootfs"; + reg = <0x800000 0x1380000>; + }; + }; + }; + }; +}; + +ðernet0 { + nvmem-cells = <&macaddr_ubootenv_ethaddr 0>; + nvmem-cell-names = "mac-address"; +}; + +&mdio_bus0 { + PHY_C45(24, 0) +}; + +&mdio_bus1 { + PHY_C45(25, 0) +}; + +&mdio_bus2 { + PHY_C45(26, 0) + PHY_C45(27, 1) +}; + +&switch0 { + ethernet-ports { + #address-cells = <1>; + #size-cells = <0>; + + SWITCH_PORT_SFP(0, 1, 2, 0, 0) + SWITCH_PORT_SFP(8, 2, 3, 0, 1) + SWITCH_PORT_SFP(16, 3, 4, 0, 2) + SWITCH_PORT_SFP(20, 4, 5, 0, 3) + + SWITCH_PORT_SDS(24, 8, 6, usxgmii) + SWITCH_PORT_SDS(25, 7, 7, usxgmii) + SWITCH_PORT_SDS(26, 6, 8, usxgmii) + SWITCH_PORT_SDS(27, 5, 9, usxgmii) + + port@28 { + ethernet = <ðernet0>; + reg = <28>; + phy-mode = "internal"; + fixed-link { + speed = <1000>; + full-duplex; + }; + }; + }; +}; + +&thermal_zones { + sys-thermal { + polling-delay-passive = <1000>; + polling-delay = <1000>; + thermal-sensors = <&temperature_sensor>; + trips { + sys-crit { + temperature = <70000>; + hysteresis = <2000>; + type = "critical"; + }; + }; + }; +}; diff --git a/target/linux/realtek/image/rtl930x.mk b/target/linux/realtek/image/rtl930x.mk index 0cb43b08d5..36fe61111e 100644 --- a/target/linux/realtek/image/rtl930x.mk +++ b/target/linux/realtek/image/rtl930x.mk @@ -94,6 +94,33 @@ define Device/vimin_vm-s100-0800ms endef TARGET_DEVICES += vimin_vm-s100-0800ms +define Device/xikestor_sks7300-4x4t + SOC := rtl9303 + DEVICE_VENDOR := XikeStor + DEVICE_MODEL := SKS7300-4X4T + DEVICE_PACKAGES := kmod-hwmon-lm75 + KERNEL_SIZE:= 8192k + IMAGE_SIZE := 28160k + KERNEL := \ + kernel-bin | \ + append-dtb | \ + lzma | \ + xikestor-sks7300-img + KERNEL_INITRAMFS := \ + kernel-bin | \ + append-dtb | \ + lzma | \ + xikestor-sks7300-img + IMAGE/sysupgrade.bin := \ + append-kernel | \ + pad-to 8192k | \ + append-rootfs | \ + pad-rootfs | \ + check-size | \ + append-metadata +endef +TARGET_DEVICES += xikestor_sks7300-4x4t + define Device/xikestor_sks8300-8t SOC := rtl9303 UIMAGE_MAGIC := 0x93000000 diff --git a/target/linux/realtek/rtl930x/config-6.18 b/target/linux/realtek/rtl930x/config-6.18 index 688447be6a..eed9581691 100644 --- a/target/linux/realtek/rtl930x/config-6.18 +++ b/target/linux/realtek/rtl930x/config-6.18 @@ -83,7 +83,7 @@ CONFIG_GPIO_PCA953X=y CONFIG_GPIO_REALTEK_OTTO=y CONFIG_GPIO_REGMAP=y CONFIG_GPIO_WATCHDOG=y -CONFIG_GPIO_WATCHDOG_ARCH_INITCALL=y +# CONFIG_GPIO_WATCHDOG_ARCH_INITCALL is not set CONFIG_GRO_CELLS=y CONFIG_HARDWARE_WATCHPOINTS=y CONFIG_HAS_DMA=y