Add a watchdog driver for the external management MCU on Hasivo /
Horaco network switches, reachable over I2C. Without periodic
keepalive the MCU resets the board every ~3 minutes.
The driver arms the MCU at probe and registers a struct
watchdog_device with WDOG_HW_RUNNING so the watchdog core feeds the
chip via a kernel timer until userspace opens the watchdog node.
Timeout is fixed at 15s; the hardware threshold is baked into MCU
firmware and is not software-configurable.
The I2C address is supplied per-board in the device tree via the
`reg` property. The driver does not constrain or probe a specific
address. Known addresses across current Hasivo / Horaco silicon:
- 0x6F: Hasivo S1300WP-8XGT-4S+, Hasivo F5800W-12S+,
Horaco ZX-SW82TS-L2P (default / most common)
- 0x6E: alternate Hasivo / Horaco variant
The driver, its device-tree binding and the Kconfig/Makefile wiring
are added to the kernel tree as a realtek target patch and exposed as
the kmod-hasivo-mcu-wdt KernelPackage. Keeping the binding in the
kernel tree lets dt_binding_check exercise it during the build and
makes the whole driver easy to drop once it lands upstream.
Tested on Hasivo S1300WP-8XGT-4S+ (RTL9313). Unbinding the driver
causes the MCU to power-cycle the board within ~15s.
Signed-off-by: Carlo Szelinsky <github@szelinsky.de>
Link: https://github.com/openwrt/openwrt/pull/23418
Signed-off-by: Markus Stockhausen <markus.stockhausen@gmx.de>
This STC8 microcontroller is used on a range of Hasivo managed switches.
It typically performs some fan/thermal control, and also has some
discrete IO hanging off of it.
The fan/thermal control is still somewhat unknown at this stage, but the
LED / gpio control has been determined as being two I2C registers which
need to be written to with a 'typical' Hasivo 0x40 execute mask set, to
change values.
Rather than having this expose the LED functionality / thermal control
directly, just represent it as an mfd, with some configurable OR'ing of
an execute-bit to certain registers (execute-bit-regs). This way different
STC8 arrangements can hopefully be handled by devicetree configs rather
than needing new driver code.
Signed-off-by: Bevan Weiss <bevan.weiss@gmail.com>
Link: https://github.com/openwrt/openwrt/pull/21578
Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
