The Xiaomi AX6000 has three radios:
- IPQ5018 integrated 2.4 GHz (ath11k AHB, wifi0)
- QCN9024 on PCIe0 (ath11k PCI, QCA8074-class 5 GHz)
- QCA9887 on PCIe1 (ath10k, 5 GHz)
The DTS previously kept pcie1 disabled because the controller
could not bring the link up. The real cause was the PERST GPIO
polarity: the stock device-tree uses GPIO_ACTIVE_HIGH on GPIO18
for the QCA9887 card, while OpenWrt had GPIO_ACTIVE_LOW, leaving
the card held in reset.
With the correct polarity the PCIe1 link trains and the QCA9887
enumerates at 01:00.0. ath10k loads firmware-2.bin, registers
phy0 with mac80211, and provides a functional 5 GHz AP.
Tested on a reworked Xiaomi AX6000 with QCA9887 soldered in.
All three radios enumerate, load firmware and beacon
successfully; scan, association and data traffic confirmed on
each radio.
Signed-off-by: chinawrj <chinawrj@gmail.com>
Link: https://github.com/openwrt/openwrt/pull/23047
Signed-off-by: Robert Marko <robimarko@gmail.com>
Align the qualcommax target to the pattern already used on other devices where
the device DTS are placed in a dedicated directory separate from the files
directory.
This, while trying to enforce a common pattern for every target, also permits to
do modification to device DTS without having to trigger a recompilation of the
entire kernel (as the files directory is not touched)
Link: https://github.com/openwrt/openwrt/pull/22037
Signed-off-by: Christian Marangi <ansuelsmth@gmail.com>
