This commit adds support for Hasivo S600WP-5GT-2SX-SE switch.
Device specification
--------------------
SoC Type: Realtek RTL9303
RAM: 128MB DDR3 SDRAM
Flash: Fudan FM25Q128A (16 MB)
Ethernet: 5x RTL8221B 10/100/1000/2500Mbps PHY (RJ45)
2x SFP+ 10G (I2C/DOM via bit-banged GPIO)
LEDs: 1x power green (no control)
1x system green (via RTL9303 GPIO)
3x RJ45 LEDs/port (HC595 shift regs on LED SPI)
1x Green (1G link)
1x Green (10M/100M link)
1x Orange (2.5G link)
2x SFP+ LEDs/port (HC595 shift regs on LED SPI)
1x 10G link
1x 1G link
Button: Reset
USB ports: None
Bootloader: Realtek U-Boot 2011.12
PoE: 1x HS104PTI for 802.3af/at/bt PoE (driver
will follow in a separate patch)
Installing OpenWrt
------------------
1. UART RJ45 requires soldering a connector to the empty footprint (RJ1).
(Amphenol RJHSEE380 or similar)
2. Connect to UART 38400@8n1, using Cisco Console Rollover cable (RS232)
3. Enter bootloader by pressing esc key during boot
4. Enter password `Hs2021cfgmg`
5. Type `XXXX` to get into U-Boot
6. Increase baudrate: `setenv baudrate 115200`
7. Use serial transfer (Y modem) via minicom:
`loady 0x84f00000`
Then send the initramfs image via minicom's Y modem upload.
8. `bootm 0x84f00000`
Now you should be in OpenWrt, and can use sysupgrade to install.
Signed-off-by: Carlo Szelinsky <github@szelinsky.de>
Link: https://github.com/openwrt/openwrt/pull/22310
Signed-off-by: Robert Marko <robimarko@gmail.com>
8275b62ecd