Device support for zbt-z8103ax-d
Model D DTS is identical to Model C zbt-z8103ax-c.
Both models share same motherboard.
Difference between models is
- Model C is a cylinder shape enclosure
containing internal antennas.
- Model D is a sandwich shape enclosure
with 6 external antennas.
Specifications:
SoC: MediaTek MT7981B
RAM: 256MiB
Flash: Winbond SPI-NAND 128 MiB
Switch: 1 WAN, 3 LAN (Gigabit) MediaTek MT7531
Buttons: Reset, Mesh
Power: DC 12V 1A
WiFi: MT7981B 2.4Ghz & 5.8Ghz
Led Layout from left to right:
Power
Mesh (RGB Led, user controllable, default set to OpenWrt Status)
WLAN 2.4G (user controllable)
WAN (user controllable)
LAN3
LAN2
LAN1
WLAN 5G (user controllable)
Installation:
A. Through U-Boot menu:
- Prepare your connecting computer to use static IP
(legacy notation) 192.168.1.10 netmask 255.255.255.0
(CIDR notation) 192.168.1.10/24
- Power down the router and hold in the Reset button.
- While holding in the button power up the router again.
- Hold the button in for 10 seconds and then release.
- Use your browser to go to 192.168.1.1
- If you see a GUI allowing for flashing firmware you are at the right spot.
- Upload the **Factory** image file.
Note: U-Boot GUI it can be used to recover from an incorrect firmware flash.
B. Through OpenWrt Dashboard:
If your router comes with OpenWrt preinstalled (modified by the seller),
you can easily upgrade by going to the dashboard (192.168.1.1)
and then navigate to
System -> Backup/Flash firmware, then flash the firmware
MAC Addresses:
MAC Addresses were found in Factory partition:
offset 0x4 F8:5E:3C:xx:xx:aa --> Router Label -2
offset 0xa F8:5E:3C:xx:xx:bb --> Router Label -1
offset 0x24 F8:5E:3C:xx:xx:cc --> Router Label +1
offset 0x2a F8:5E:3C:xx:xx:yy --> printed on Router Label
Signed-off-by: Jörg Seitz <github.joeterminal@xoxy.net>
Link: https://github.com/openwrt/openwrt/pull/21626
Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
b84184a526