catspeed-cc/tew-829dru-goldrepo
1
0
Fork 0
Code Issues Pull Requests Actions Packages Projects Releases Wiki Activity

Update README.md

Browse Source
This commit is contained in:
MooCat 2026-06-16 02:01:46 -04:00 committed by GitHub
parent 45ba1e4955
commit 18c2f8f478
Signed by: mooleshacat
GPG Key ID: B5690EEEBB952194
1 changed files with 8 additions and 6 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

14
README.md
View File

@ -56,7 +56,7 @@ Target: ipq40xx
Subtarget: generic
Package architecture: arm_cortex-a7_neon-vfpv4
Bootloader: U-Boot
CPU: Qualcomm Atheros IPQ4019
CPU: Qualcomm Atheros IPQ4019 SoC
CPU Cores: 4
CPU MHz: 717
Flash MB: 8, 128 (Macronix MX25L6433F SPI NOR / Micron MT29F1G08ABADA NAND)
@ -68,11 +68,11 @@ Ethernet 5Gbit ports: -
Ethernet 10Gbit ports: -
SFP ports: -
SFP+ ports: -
Switch: Qualcomm Atheros QCA8337, Qualcomm Atheros QCA8075
Switch: Qualcomm Atheros QCA8075, Qualcomm Atheros QCA8337
VLAN: Yes
Modem: -
Comments network ports: 2 WAN + 8 LAN Port Switch
WLAN Hardware: Qualcomm Atheros IPQ4019, Qualcomm Atheros QCA9984
WLAN Hardware: Qualcomm Atheros QCA4019, Qualcomm Atheros QCA9984
WLAN 2.4GHz: b/g/n
WLAN 5.0GHz: a/n/ac
WLAN driver: ath10k
@ -123,7 +123,7 @@ QCA4019 firmware identifier: bus=ahb,bmi-chip-id=0,bmi-board-id=28,variant=TEW-
- This is a quad core, 717 Mhz, 256MB RAM IPQ4019 device
- This device is based off the Qualcomm ap.dk04.1-c1 SDK development board
- This is a Dual Switch Architecture device (QCA8337/QCA8075)
- This is a Dual Switch / Dual MAC Architecture device (QCA8337/QCA8075)
- This device has a redundant setup with two flash chips:
- Macronix MX25L6433F SPI NOR - for the single bootloader setup
@ -169,7 +169,9 @@ Note: Working on obtaining LED & switch/phy reset GPIO's
Note: TRENDnet does not provide GPIO mappings - failing to comply w/ GPL & provide proper CCS
LOGICAL GPIO ACTUAL GPIO FUNCTION
6 518 mdio0 (determined following hardware lineage)
7 519 mdc (determined following hardware lineage)
48 560 usb-power-enable -> drive HIGH to enable USB power (finally found it via probing!)
@ -719,5 +721,5 @@ You can make a tmp/ directory, enter it, and run the extraction command in order
Should the JSON look correct (has both entries if there are two) and there are all bin files present (with different names is ok) then you completed a "round trip".
The files are ready for insertion into your dev environment and built into the image.
The files are ready for insertion into your dev environment and to be built into the image.
```